Zenit C Manuel d'instructions télécharger pdf (Page 11)

7. Replace the bottom cover, press it down tightly and give the latch ring

28 (

Fig. 4) one-half turn clockwise. The latch arrow should then point to

"Close"

(originally: "закр." -- an abridgment to Cyrillic 'закрыто' --

close)

. The magazine slit automatically opens freeing the film, as the lock

is closed.

8. To deliver an unexposed portion of the film to the negative window,

wind up the shutter tree times, pressing the release button 11 after each

winding. When winding the shutter mechanism, check to see whether

film rewinding knob 15 is rotating.

If the knob does not rotate, check whether the film has been loaded into

the camera correctly. Note that this may also take place during the first

few shots if the magazine was loaded with a film much shorter than

normal length. In this case the rewinding knob starts to rotate only when

the film tension on the spool is sufficient.

9. Set the picture counting dial 9 at "0" opposite the counter index 10.

TAKING THE PICTURES

The camera may be operated or set on a tripod or on horizontal surface.

When preparing to take the picture it is advisable to follow the steps

listed bellow:

1. Make sure that the shutter mechanism is engaged i.e. the points on the

ring 7 and the release button 11 coincide with the point on the top side.

Look at the picture counting dial to make sure whether there is any

unexposed film left in the camera.

2. When using a flash bulb, screw the illuminator to the tripod nut on the

camera, set the synchronizing scale and connect the bulb to the camera as

it is described before.

3. If necessary, fix the camera to the tripod and screw the cable release

into the release button.

4. Remove the lens cap.

1 2 ... 6 7 8 9 10 11 12 13 14

Pas de commentaire

Zenit C Manuel d'instructions Page 11