Zenit C Manuel d'instructions télécharger pdf (Page 12)

5. If necessary, attach a filter..

6. Open the lens opening fully by turning the front lens ring 21 until it

stops.

Just before taking a picture it is necessary:

1. Wind the shutter by turning the shutter winding knob 8 in the direction

of the arrow as far as it will go.

2. Determine the required exposure speed and set it with the exposure

setting ring 12 as indicated before.

3. Adjust correct focus by turning the knurled ring 19 and viewing the

image of the object through the eyepiece 5.

Note. If the image remains sharp when the ring is rotated through a

certain angle, it should be set in the middle of that angle.

4. Set the required lens opening by turning the ring 21. When setting the

lens opening it is recommended to hold the ring 19 in order to avoid

unfocusing of the camera.

5. Make the exposure by slowly pressing the release button 11. Take care

not to move the camera during the exposure, or the picture may be

blurred.

When taking the picture with the camera in the carrying case, see that the

case cover does not get between the object and the lens.

CAMERA UNLOADING

When the film is entirely exposed the camera has to be unloaded.

For this purpose:

1. Cover the lens with its cap.

2. Turn the ring 7 so that its point moves towards the letter "R"

(originally: "П" -- Cyrillic "P", from 'перемотка', 'peremotka' --

rewinding)

to a stop.

3. Rewind the film back into the magazine by rotating the film

rewinding knob 15 in the direction indicated by the arrow.

4. Open the camera as described before.

Note. When opening the camera, the magazine slit closes

automatically, therefore, to avoid spoiling the film, the cover

should not be removed until the lock is at a stop.

5. Remove the magazine from the camera.

6. Turn the ring 7 until its point is opposite to that on the upper side

of the camera. This re-engages the camera mechanism.

1 2 ... 7 8 9 10 11 12 13 14

Pas de commentaire

Zenit C Manuel d'instructions Page 12